Knowped & Growped Grindplate Installation*
Step 1
Step 1
Step 1
Loosen your existing deck hardware and remove all hardware that is located beneath the deck mounts under the frame (including existing deck bolts).
Step 2
Step 1
Step 1
One by one, replace each of your existing deck bolts with a 1-1/4" bolt provided in your hardware kit. Blue Locktite may be used.
Step 3
Step 1
Step 3
Slide each of the 1" bolts through the bolt holes on the grindplate. Blue Locktite may be used.
Step 4
Step 4
Step 3
Find the largest spacer (7/32") and put one on each bolt.
Step 5
Step 4
Step 5
Thread each of the 1" threaded standoffs onto each bolt and tighten by hand until snug.
Step 6
Step 4
Step 5
Position the grindplate under the main deck bolts. Locate a 13/64" spacer and slide it onto a deck bolt. Then, thread the deck bolt into the standoff slightly. Repeat the process for the three remaining bolts. Finally, use a criss-cross tightening sequence to secure the deck and grindplate.
bigfoot/gsr GRINDPLATE INSTALLATION*
Step 1
Step 1
Step 1
Loosen your existing deck hardware and remove all hardware that is located beneath the deck mounts EXCEPT the washers (keep these).
Step 2
Step 1
Step 1
One by one, replace each of your existing deck bolts with a 1-1/2" bolt provided in your hardware kit. Blue Locktite may be used.
Step 3
Step 1
Step 3
Slide each of the 1" bolts through the bolt holes on the grindplate. Blue Locktite may be used.
Step 4
Step 4
Step 3
Place one washer on each bolt on top of the grindplate. Note: If you want the grindplate to sit against the frame skip this step.
Step 5
Step 4
Step 5
Thread each of the 1-3/4" threaded standoffs onto each bolt and tighten by hand until snug.
Step 6
Step 4
Step 5
Position the grindplate under the main deck bolts and begin to thread the deck bolts into the standoffs using a criss-cross tightening sequence. Place one of the washers you saved in Step 1 in between each stand-off and the deck mount tabs.
Step 7
Step 7
Step 7
Inspect the grindplate and ensure no washers slid out during installation. Torque the deck and grindplate bolts appropriately.